Diamond wire saw rope is suitable for cutting reinforced concrete, stone and other materials.
Operating Specifications:
1. When using, straighten the rope and twist it according to 1-2 turns/meter, which can effectively prevent partial wear, and then connect the wire saw into a closed loop with hydraulic pliers and press buckles. Before cutting, be sure to distinguish the using direction of diamond wire saw rope, and do not rotate in the opposite direction for cutting.
2. Try to avoid acute angle cutting during use to avoid damage to the rope, and increase the support guide wheel if necessary.
3. The wear of the guide wheel will reduce the fit between the wire saw and the guide wheel, which will affect the wire speed of the wire saw, and thus affect the cutting efficiency. It is necessary to replace the rubber ring of the guide wheel in time.
4. When diamond wire saw rope is cutting, it must be cooled, and the amount of water can be adjusted according to the noise during cutting and the turbidity of the cooling water. The amount of cooling water is not as much as possible. Too much cooling water can easily affect the self-sharpening of the wire saw and make the wire saw slip. Too little cooling water can easily cause the beads to heat up and affect the cutting life.
5. Pay attention to ensure the tensioning force. If the tensioning force is too small, the cutting speed will be slow, and the rope will be easily disconnected.
6. When the diamond wire saw rope is not in use, the tension should be unloaded and stored in a dry place.
7. Safety operation specification:
wire saw equipment should comply with national or related standards.
There must be safety isolation facilities and personal protection measures around the working surface of the wire saw on the construction site before construction.
Under the working state of the product, personnel must stay away from the working surface for about 15 meters away, and it is strictly forbidden for personnel to stay in the tangent area in the running direction of the wire saw; if on-site maintenance is required, the operation must be stopped.
During using, part of the beads loose is a normal phenomenon due to wear and impact, etc. After completing a cutting operation, the product status must be checked, and the loose parts of the beads should be cut off, or stop using the product.